Measuring in 2D mode

<< Click to Display Table of Contents >>

Navigation:  Viewer > Getting Information >

Measuring in 2D mode

ABViewer has a group of instruments allowing to measure the elements of a drawing. The measurements can be performed in meters, millimeters and inches regardless of the units in which the drawing is made. It is possible to set a customer scale factor. The instruments are available in all the versions and modes of the program.


This command allows measuring a distance between two points in the drawing.

Polyline Length

This command allows measuring the length of polyline sections in the drawing and the angle formed by these lines.


This command allows measuring an area in the drawing.

Measure panel

The floating panel in which the performed measurements are displayed.

Go to ABViewer